Pour 50 lbs sand plus D1 components into the mixing tub and start the mixing process. Whilst mixing, slowly add the separately packaged components completely into the mixture.
After mixing for 3 minutes add water according to the product package and continue mixing well for at least 3 minutes.
Pre-wet the surface. Porous surfaces as well as higher surface temperatures, require more intense pre-wetting.
Apply the mixed paving jointing mortar onto the well moistened surface and work it carefully into the joints using a squeegee/rubber slider. The mortar is poured out at three or four spots within the jointing area in order to make best use of the fluidity of the paving jointing mortar.
After approx. 10 – 15 minutes the excess mortar on the surface of the stones can be swept off carefully with a large, coarse broom.
The correct moment for sweeping, is when white smears no longer form on the stone surface during sweeping. Sweeping should be done diagonally to the joint. Do not re-use swept off material.
Pour 50 lbs Sand plus the D2000 filler components completely into the mixer and start the mixing process. After mixing for 3 minutes add approx. 100 ounces /0,8 gal/3 liters of water and continue mixing well for at least 3 minutes.
Pre-wet the surface. Porous surfaces as well as higher surface temperatures, require more intense pre-wetting
Note: The surface to be joint-fixed should be cleaned of all impurities before work commences.
work it carefully into the joints using a squeegee/rubber slider. In order to use the flow capability of the paving jointing mortar, it should be poured onto three or four areas of the jointing area.
After approx.10 minutes, the excess mortar on the stone surface can be swept off carefully with a large, coarse broom.
Use a soft, hair broom to do a final cleaning until all residual mortar has been removed from the surface.
Now thoroughly spray the paved surface with a fine water spray (distance of spray nozzle to stone surface approx. 3 feed.